[lists] 0=&Cover, Aircraft Checklist Junkers Ju-87 1=&Takeoff, Takeoff Checklist 2=C&ruise, Cruise Checklist 3=&Descent, Descent Checklist 4=&Landing, Landing Checklist [0] 0=Note - press shift+C to cycle the following checklists: 1=1. Takeoff 2=2. Cruise 3=3. Descent 4=4. Landing [1] 0=To start engine - press the "E" key. 1=Check flight controls. 2=Smoothly increase throttle. 3=Hold tail down until sufficient speed (80-90km/h) is attained, then raise tail slowly. 4=At about 110-120km/h, ease back on the stick. 5=Gradually adjust pitch attitude to climb at 180km/h. [2] 0=Establish level flight. 1=Power setting for cruise at 6.500m, 1200rpm - 1.28 ATA = 180km/h. 2=Adjust elevator trim (Num Pad 7 = nose down, Num Pad 1 = nose up). [3] 0=Reduce power to maintain glide speed of approximately 120km/h. 1=Relax pressure on the controls and the airplane will descend. 2=To level off, increase power to original cruise setting. [4] 0=Reduce power to maintain glide speed of approximately 120km/h. 1=Flaps as needed. 2=Adjust power settings for 110km/h final approach. 3=Over runway (90-105km/h), establish slight nose-up attitude. Reduce throttle to idle.